Most asked question

1:how do i hack my decoder or digital TV??

Answer

It all about a software
1.if your decoder has a USB port there is a software for that,you’ll put it in an empty flash disk then to the USB port,then go to settings,upgrade option/software update,press okey,, it should count upto 100%,and after its through, switch it off then on then automatic search and you’re good to go

2.if it doesn’t have a USB port,it obviously has a smartcard number or ICU number,there’s a software for that,take the ICU number /smartcard number, and put it in the software then press start,make sure the decoder is on and within 5 minutes it will be though.The decoder should also count upto 100% and after that you’ll be through

3.For free to air decoders use the same software as number 2 but this time put the serial number of your decoder then follow the same procedure as number 2

4.DIGITAL TV
Take the software put it into an empty flash disk then to USB port then go to settings>>upgrade option/software update then press okey,,it will count upto 100% and after that switch off then on then automatic search

In simple words ,this is all about upgrading the firmware of your decoder/digital TV

Contact our expert

Click. Here